KEB COMBIVERT F5 Series, Инструкция по эксплуатации

Страница: 34 / 72

5 Installation
5.1 EMC-compatible control cabinet installation
1a Mains fuse
150 mm
30 mm
150 mm
1a
5a
2a 2b
6
7
9b
8
9c
9a
10
10a
11
5
3
4
1b
150 mm
1b Pre-charging fuse
2a Pre-charging contactor
2b Main contactor (before LCL filter)
3 EMC filter
4 AIC/LCL filter (if necessary integrat -
ed in 4)
5 COMBIVERT F5-AIC
5a If necessary external load-shunt
6 External DC fuses
7 Drive converter
8 Motor cable
9a Power unit equipotential bonding
with the housing earth
9b Protective Earth (PE) on the mount-
ing plate power circuit
9c Protective Earth (PE) on the mount-
ing plate control circuit
10 Mains connection power circuit
10a Mains connection control circuit
11
Control lines
Large area contact at the mounting
plate
Control circuit Power circuit Direction of the
cooling fins
Table 14: EMC-compatible control cabinet installation
5.2 Installation instructions
• Stationarily install and earth COMBIVERT.
•
Allow for sufficient heat dissipation if installed in a dust-proof housing.
• Install the COMBIVERT in an appropriate housing in accordance with the local reg-
ulations when operating it in explosion-endangered spaces.
• Protect COMBIVERT against conductive and aggressive gases and liquids.
•
The AIC/LCL filter must be placed in the immediate vicinity of the AIC.
• The drive converters must be placed in the immediate vicinity of the AIC.
• The DC connection lines must be kept as short as possible.
• The use of ferrites on the DC line is not permitted.
34
INSTALLATION