KEB COMBIVERT F5-A, Руководство по применению, Страница: 507 / 552

Network components
© KEB, 2012-10 COMBIVERT F5-A, -E, -H Page 10.1 - 11
10
10.1.9.8 Status and control word
The control word is used for the status control of the inverter via bus. The actual state of the inverter can be
read out with the status word.
The control word low is bit-coded designed as follows.
SY.50: Control word low
Bit Function Value Description
0
Control re-
lease
1: ST
This bit is only effective if di.01 „select signal source“ bit 0 is
set. Then the AND operation of this bit with di.02 „digital input
setting“ bit 0 is valid.
1 Automatic 2: RST
An error reset is executed when changing from not activated (0)
to activated (2).
2 Start / stop
0: Stop
Direction of rotation release or the „start “(„run “) command can
be given via the control word, if oP.01 „rotation source“ contains
the values 6, 8, 9 or 10.
4: Start
3
Clockwise /
counter clock-
wise rotation
0: Clockwise
rotation
If oP.01 „rotation source“ contains the values 8 or 9, the direction
of rotation is preset via this bit.
8: Counter-clock-
wise rotation
4...6 Parameter set
0: Set 0
Selection of the active parameter set, if in Fr.02 „parameter set
source“ the value „5: control word (SY.50)“ is programmed
16: Set 1
32: Set 2
48: Set 3
64: Set 4
80: Set 5
96: Set 6
112: Set 7
7 reserved
8
Fast stop on
/ off
256: Fast stop Releases fast stop (OR operation with further fast stop sources).
9
Start approach
to reference
point 512: Start ap-
proach to refe-
rence point
Change of not activated (0) to activated (512) starts approach
to reference point.
10
Start Positio-
ning 1024: Start Posi-
tioning Change of not activated (0) to activated (1024) starts the posi-
tioning.
11 Interruption 2048: Interruption
Change of not activated (0) to activated (2048) stops the positio-
ning (drive is stopped with ramp according to positioning profile)
12, 13
Operating
mode
0: off
Selection of the operating mode via the control word.
Only valid if in PS.00 „posi/syn mode“ in bits 0..2 value „7: via
control word“ is programmed)
4096: Synchro-
nous running
8192: positioning
12288: Contou-
ring control
14, 15 reserved