KEB COMBIVERT 07H6 Series, Инструкция по эксплуатации

Страница: 52 / 74

4.2.3.7 Use of the temperature input in PTC mode
If the temperature input is operated in the PTC mode, the user can provide all possibili-
ties within the resistance range specified in chapter „Motor temperature detection“. This
can be:
Thermal contact (Nc contact)
T1
T2
Temperature sensor (PTc)
T1
T2
Mixed sensor chain
T1
T2
Table 15: Wiring example in PTC mode
If no evaluation of the input is desired, a bridge between T1 and T2 pn12 can
be installed or the error message can be ignored with pn12.
4.2.3.8 Brake control terminals B+, B-
Terminal block X1b Name Description
B+
B-
X1B
U
dc
= 24V
I
_max
= 3,3A
b+
DC 24 V / max. 3.3 A output for direct control of
a brake. The max. current is depending on the
number of axes and the rectifier module.
b-
Figure 25: Brake control terminals B+, B-
4.2.3.9 Brake control terminals BA+, BA- and BB+, BB-
Terminal block X1b Name Description
BA+ / BB+
X1B
U
dc
= 24V
I
_max
= 2A BA- / BB-
bA+ /
bb+
DC 24 V / max. 2 A output for direct control of
a brake. The max. current is depending on the
number of axes and the rectifier module.
bA- /
bb-
Figure 26: Brake control terminals BA+, BA- and BB+, BB-
52
cONNEcTION Of THE POWER UNIT