KEB COMBICOM, Инструкция по эксплуатации

Страница: 8 / 24

GB - 8
Powerlink Operator
EPL_STATUS : Red LED in accordance with the specification "STATUS Led` in the Powerlink specification ([1]):
LED example Description
constantly off NMT_GS_OFF, NMT_GS_INITIALISATION,
NMT_CS_NOT_ACTIVE
cyclic flickering with ON(50ms) / OFF(50ms) NMT_CS_BASIC_ETHERNET
single lightning with ON(200ms) / OFF(1000ms) NMT_CS_PREOPERATIONAL_1
double lightning with ON(200ms) / OFF(200ms) /
ON(200ms) / OFF(1000ms)
NMT_CS_PREOPERATIONAL_2
triple lightning with ON(200ms) / OFF(200ms)
/ ON (200ms) / OFF(200ms) / ON (200ms) /
OFF(1000ms)
NMT_CS_READY_TO_OPERATE
constantly on NMT_CS_OPERATIONAL
cyclic flashing with ON(200ms) / OFF(200ms) NMT_CS_STOPPED
X6B: RJ45 socket of the diagnostic interface (Combivis):
Attention !!! To prevent the damage of the serial interface on your Personal Computer be sure that you use the
special HSP5 cable from KEB for connecting your PC to the serial interface of the ModBus operator.
X6C , X6D : Standard Ethernet-RJ45-connector in accordance with IEEE 802.3 100Base-T:
3. Software
3.1 Fundamentals of the KEB-Powerlink connection
The KEB-F5-Powerlink operator contains a separate Powerlink slave controller for processing of time-critical
communication tasks. An extensive Powerlink compatibility is also ensured by using this external component. The
supported Powerlink versions are EPL V1 and EPL V2.
Technical data of the Powerlink interface:
Supported Powerlink version(s) EPL V1, EPL V2
Response Time 2 µs
3.1.1 EPL-Command-Layer protocol(parameter channel)
The Command-Layer-protocol’ is supported by the KEB-F5-Powerlink operator. Thus it is possible to address any
parameter itself in the FI control and in the Powerlink operator via acyclic SDO protocol. The supported services
on the "COMMAND Layer" are:
Expedited Download Transfer with Write-by-Index as Server (writing of a parameter via index, subindex) •
Expedited Upload Transfer with Read-by-Index as Server (reading of a parameter via index, subindex) •
Parameter-addressing with 16-Bit index plus 8-Bit subindex
1.Index Last index Description
1000h 1FFFh Communication parameter in accordance with [2]
2000h 5FFFh Parameter of FI control and operator with index = KEB-Parameter-Address +
2000h(*1). KEB uses he subindex for set-addressing.
6000h 9FFFh Parameter of the unit profile DSP402 in accordance with [4]
(*1): The KEB parameter address can be found here or in [3]. It is also possible to display the KEB parameter
address in the KEB start-up software COMBIVIS. See annex for specific informations.