GB - 12
Powerlink Operator
4. Operator Parameters
The operator parameters are managed by the Powerlink operator. Access to this parameters can be done through
diagnosis-interface with KEB-COMBIVIS software or through the SDO channel of Powerlink. The following list
containes only those parameters which are important for the user. . All other parameters are for debugging-purpo-
ses and have not to be changed by the user.
Name:
Com_Cycle (Fb00)
Meaning:
Indicates the adjusted SoC interrupt cycle time in µs.
Combivis-
Parameter address:
0280h
SDO-Index:
2280h
SDO-Subindex:
0
Data length:
4 Byte
Access:
READ_ONLY
Coding:
1 µs
Notice:
Name:
HS_SyncToutMode (Fb01)
Meaning:
Defines the reaction on a SoC-interrupts timeout. Der Sync timeout is given, if no SoC-
interrupt has been received since four times of the cycle time set by Com_Ccyle.
Combivis-
Parameter address:
0281h
SDO-Index:
2281h
SDO-Subindex:
0
Data length:
1 Byte
Access:
READ_WRITE
Coding:
0: Automatic return to normal mode.
Otherwise: Switch to Auto-synch-mode. In this mode SoC-Interrupts are emulated timer
controlled. As cycletime the value of Com_Cycle is used.
Default value:
0
Notice:
A changed value takes effect immediately and is stored non-volatile.
Name:
HS_SyncToutDelay (Fb02)
Meaning:
Defines the number of SoC-interrupts, after which the SoC-interrupt-supervising is acti-
vated.
Combivis-
Parameter address:
0282h
SDO-Index:
2282h
SDO-Subindex:
0
Data length:
2 Byte
Access:
READ_WRITE
Coding:
1
Default value:
0
Notice:
A changed value takes effect immediately and is stored non-volatile.
Name:
FBS Command (Fb04)
Meaning:
Through writing to this parameter certain commands can be requested in the Powerlink
operator.
Combivis-
Parameter address:
0284h
SDO-Index:
2284h
SDO-Subindex:
0
Data length:
2 Byte
Access:
READ_WRITE
Coding:
0: No command
Содержание COMBICOM
