Begin Walking
•
Position your body inside the Vizziq
™
; it will surround
you and move with you. Move naturally with your arms
comfortably near your sides and allow your body to
experience the dynamic stability of the Vizziq
™
.
You should feel supported while allowing for natural
movements through your torso and hips.
•
The lower handgrips will provide some lower-body
unloading for less weight bearing, if recommended by
your health provider. If unloading is desired, position the
handle bars lower so that the user’s elbows are slightly
bent while holding and slightly pushing down on the
lower handgrips. Position the height of the handgrips
so the user is relaxed through the neck, upper trunk and
shoulders, and can stand comfortably. Position wrists at
the most comfortable level.
QUICK REVIEW
1 Lock the wheels - pull hand loop out/down.
2 Non-pivoting/locked Method: Insert pin
through the center cross bars.
3 Grasp the handlebars.
4 Stand tall inside the Vizziq™ frame.
5 Keep arms close to your body.
6 Squeeze brake handle to unlock wheels.
7 Walk naturally staying inside the frame.
Stand tall. Look straight ahead.
8 Pivoting Method: Remove pin to engage
the pivoting feature and repeat 3-7.
Folding / Storing the Vizziq
™
•
Stand inside the Vizziq
™
with four wheels in contact
with the ground.
•
Unlock the device by removing the center detent pin
and place it in the storage hole on the center front
crossbar. Disconnect the side frames by releasing the
quick connector. Slide the outer sleeve back until the
socket is fully open and lift off the ball stud.
•
To position the Vizziq
™
for
folding/storage, swing the
left leg out (clockwise)
followed by swinging the
right (leg with Vizziq
™
label) counterclockwise so
the tie rod with springs is
positioned parallel, along
the inside of front crossbar.
Secure with rubber twist
tie looping through center
and tighten.
•
If needed for storage or
transit, shorten or remove
handlebars by disassembling
from frame: Loosen the
retention knob and remove
the back plate. Remove total
adjustment assembly so
that handlebars move freely
up, down or if necessary,
handlebars may be completely
removed from rear frame.
Store the adjustment assembly
parts in the frame if removing
handlebars.
DISCLAIMER
KC Product Development is not responsible for any injuries, product failure or any injury or malfunctioning during use of Vizziq™.
Contact KC Product Development, L.L.C. 2916 Hilldale Ave NE Mpls, MN 55418 or call 612.598.1702, if you have any questions or concerns regarding your Vizziq™ .
Copyright © 2018 by KC Product Development, L.L.C.
4
