KBi KAPower MKSM Series, Руководство по эксплуатации

Страница: 9 / 34

9
6. The 4 Pin Deutsch connector has been supplied with a mating connector. Be sure to
follow proper wire schemes as identified in the diagrams.
7. The supplied DPST switch may be installed in addition to or paralleling the existing key-
start switch. Locate and install the DPST switch in a convenient location relative to the
key switch.
4.2 Mounting the MKSM Unit
Using the dimensions shown in Figures 3, and 4, use four (4) ¼” bolts, nuts, and lock washers
(not supplied) to mount the MKSM unit to vehicle, vessle, or equipment chassis . If mounting on
a soild bulkhead or other location without backside acsess, other fasteners such as suitably-
sized self tapping screws can be used.
When selecting a location for installation, make sure that the MKSM module and cables will
clear any hoods, hatches, lids, covers, and other movable vehicle, vessel or equipment
parts. Avoid locations that are subject to extreme heat, dripping water, humidity, road dirt,
ice, and snow. While the MKSM unit may be mounted in any position or orientation, do not
mount it directly over batteries, or under ventilation systems through which water might
drip. The internal components of the MKSM are IP67 rated, but the MKSM itself is not IP
rated. Take care to prevent the external case of the MKSM module from receiving any
physical impacts.
CAUTION