eCopper™
QSG-EERF1-LS1-T-IN-B_Series-Rev1808
www.kbcnetworks.com
Copyright © KBC Networks 2018
Quick Start Guide
EERF1-LS1-T-IN-B
EoU Transmitter
–
1 UTP with fly cable and 1 RJ45
Introduction
The KBC EERF1-LS1-T-IN-B is a fully ruggedized Ethernet over UTP transmitter.
This transmitter provides connectivity for one 10/100Mbps IEEE standard
electrical copper port over UTP cable. Power is supplied from one of the
headend Receivers, EERF16-G3-R-RX-B, EERF8-G3-R-RX-B, EERF4-DN1-R-WN-B
or EERF1-LS1-R-MN-B Ethernet over UTP units through the UTP cable by Power
over Wire (PoW) technology. The transmitter provides PoE+ support. Varying
data rates are supported depending on cable distance and quality. The plug-
and-play design ensures ease of installation with no electrical adjustment
needed. LED indicators are provided to clearly show the operational status of
the unit.
In order to minimize size, the Ethernet port of the transmitter is with flying
cable, so that the size of the transmitter is suited for fitting inside camera
housings and where space is minimal.
Features
•
802.3af/802.3at compliant
•
Power over Wire
•
UTP data rate >40Mbps (300m)
•
Based on cable quality, cable pairs used (1,2 or 4 pairs) and voltage
applied to cable (48~57VDC) from headend, PoE and PoE+ are supported
by PoW up to 400m.
•
Powered by PoW from EERF16-G3-R-RX-B , EERF8-G3-R-RX-B, EERF4-DN1-
R-WN-B or EERF1-LS1-R-MN-B headend
•
Complete protection design including surge protection, lighting
protection
•
Unique PoW transmission protection design together with 1,4,8 or 16
channels receiver headend
Downloads
Full specifications, features and additional information can be found on the
relevant product page on the KBC website as well as in the downloads section:
