Kaye ValProbe RT, Руководство пользователя

Страница: 133 / 168

Chapter 11: Qualification Reports
Kaye ValProbe RT User Manual 120
11.8. Generating Qualification Reports
Before selecting a report type, the ValProbe RT software permits the user one last opportunity
to verify or edit parameters such as:
•
Start / Stop conditions (Marking Cycles)
•
Sensor groupings
•
Sensor calculations
Using these parameters, any errors or omissions can be corrected before generation of the
report.
These changes do not affect the raw sensor data, or storage rate of the Qualification file. All
changes made during these steps are documented in the report.
To begin the Qualification report generation, perform the following steps.
Selecting a Qualification File
To select the Qualification file, select the Asset where the Qualification was initiated from.
Select the
Qualification tile, then the desired raw encrypted Qualification file and press the
Generate Reports button.
Select the Bar Graph icon for the selected Qualification file.
A Select Sensor Type pop-up appears requesting the measurand type to graph when defining
cycles. Select the appropriate sensor type and press
OK to open the Mark Cycles Graph. For
sterilizers, the option to use both temperature and pressure provides a better understanding
for when both requirements are reached.
Figure 127: Select Sensor(s) Type
Mark Cycles
Before generating Qualification reports, use the Define Qual/ Exposure screen to review, or
modify, the Qual Start/ End and or Exposure Start / End cycles times from the Qualification
study data. Each cycle is defined with a start and end time which define the cycle duration.
The defined cycles are used in the Qualification Summary and Pass/Fail Criteria report to
provide detailed calculations and analysis during specified cycles.