2 0 H a M e s i l a S t . , N e s h e r 3 6 8 8 5 2 0 , I s r a e l
P O B 2 5 0 0 4 , H a i f a 3 1 2 5 0 0 1 , I s r a e l
T e l : ( + 9 7 2 ) - 7 2 - 2 7 2 3 5 0 0 F a x : ( + 9 7 2 ) - 7 2 - 2 7 2 3 5 1 1
Page no. 7 | Hardware Reference
5
Hardware Reference
5.1
Power over CoaXPress
Iron CoaXPress cameras support PoCXP (Power over CoaXPress), but must never be connected to an external
power source whilst receiving power through PoCXP. Powering the camera with an external power source and
over CoaXPress simultaneously may cause irreversible damage.
!
Never connect an external power supply to CoaXPress cameras when PoCXP is enabled on Frame Grabbers
5.2
Micro BNC Connector
To connect the Micro-BNC cable, first need to align the pin on the male end with the “L” shaped track on the
female-connector of the Coaxial cable. Once aligned, the connector should be pushed in place (see figure no. 1).
Only mild pressure should be applied to achieve this operation, otherwise it may cause unnecessary damage to
the cable or the card.
Figure 1 – Pushing the Micro-BNC connector into place
Once pushed all the way through, twist the connector clock-wise. The pin will move in the track locking the
connector in position:
Figure 2 – Twisting the connector and securing it in position
The cable can be removed by reversing the steps: twisting the connector counter-clock-wise and pulling it out.
