6 Installation of the imaging plate system
KaVo Scan eXam One
39
3.
PC:
Install the imaging application software to
be used
in the PC(s).
4.
PC:
Open the imaging application software and
select the scanner setup window.
5.
PC:
From the scanner setup window select the
Settings tab to open the Scanner Connection
page.
6.
PC:
Select Direct Connection.
Key the serial number of the unit into the Scanner
serial number field. The serial number of the unit
appears on the type label on the back of the unit.
Make sure that the Computer network connection
that provides the LAN network connection is
selected.
6.4.2 IP method (using the unit static
address)
If your system does not allow the direct connection
method to be used to connect the PC(s), connection
can be done using an IP address.
1. Follow steps 1 to 5 from the previous section,
Direct connection method (uses the unit s/n).
2.
PC:
From the Settings tab select IP based and
then select the Enable changing IP address box.
Obtain an IP address for the unit from your net-
work administrator and key it into the IP field in
the Scanner IP address area.
NOTICE!
The PC and the unit must be in the
same subnet when setting the IP address of the
unit.
3.
PC + Unit:
Press and hold down the Start key
on the unit and then click Send to Scanner on
the settings window. You hear a beep which in-
dicates that the PC is now sending the IP ad-
dress the unit.
4.
PC:
Click
OK
to connect the PC to the unit.
5. Now connect the other PCs in the network to the
Approved:
Reviewed: Jalkanen Joni 2017-02-13 16:00
Reviewed
See PDM system to determine the status of this document. Printed out: 2017-03-17 10:35:17
D510414, 5
Copyright © by PaloDEx Group Oy. All rights reserved.
