KaVo ORTHOPANTOMOGRAPH OP 3D Pro, Руководство по обслуживанию, Страница: 123 / 192

115
7 Error codes and troubleshooting
7.1 Initial actions
Note!
Blurring can occur on the upper corners of the cylin-
derical 3D volume. Nevertheless, the best possible image
quality relative to the selected resolution is presented.
Error codes
When an error code appears on the display the unit will
stop working and cannot be operated while the error code
is on the display.
Acknowledging errors
The unit responds to error situations by reporting an error.
Most errors may be acknowledged using the touch screen
display (by closing the dialog box the error is reported in).
Some errors require the unit to be rebooted. If such an
error occurs, or if the unit fails to operate as described in
the user’s manual, switch the unit off, wait a few seconds
and the switch the unit on again.
Image transfer
If an image is not transferred successfully to the PC, close
and then reopen the dental imaging software and/or restart
the PC.
DO NOT restart the unit as this will erase any image that is
stored in the unit memory and this retrievable image will be
lost.
7.2 Checking the unit
Diagnosing faults with the s2terminal
The s2terminal includes commands that allow the
operation of the unit to be checked.
Unit service commands:
-
systemstatus
, allows the functionality of the op-
tosensors, switches and micro switches to be
checked.
-
drivemotor x
(x = the motor name), allows the op-
eration of the different motors to be checked.