KaVo EXTRAmatic 9040, Инструкция по эксплуатации

Страница: 38 / 56

Instructions for use EXTRAmatic 9040
5 Operation | 5.3 Utility programs
38 / 56
80 (230 V)
260 (100 V)
200 (120 V)
▶ Press the back button
ð
This takes you out of the utility program.
5.3.9 "Display of the socket current" utility programm (2400)
▶ Using the the up or down button, select the "Socket current" utility program and
choose ENTER.
▶ Using the up or down button, select the required workstation (AP1, AP2 or AP3).
▶ Press ENTER.
ð
This displays the present measured current status at the selected workstation.
This value does not have a unit.
It is identical to the values in the "Automatic sensitivity adjustment" and "Manual sensi‐
tivity adjustment" utility programs.
▶ Press the back button
ð
This takes you out of the utility program.
5.3.10 "Active carbon filter control" utility program (2500)
▶ Use the "Up" and/or "Down" buttons to start the auxiliary programme, "Carbon fil‐
ter monitoring", and press the "ENTER" button.
▶ Use the "Up" and/or "Down" buttons to enter yes or no.
No = the active carbon filter service life is not recorded
Yes = the active carbon filter service life is recorded
Factory setting: no
▶ Press ENTER.
ð
This saves the new value that has been set.
5.3.11 "Time to change active carbon filter" utility program (2450)
▶ Use the "Up" and/or "Down" buttons to start the auxiliary programme, "Carbon fil‐
ter time", and press the "ENTER" button.