KaVo 0.535.6180, Инструкция по эксплуатации

Страница: 16 / 28

Instructions for use INTRAflex LUX 2 Programm 2307 LN - 0.535.6190, 2320 LN - 0.535.6180, 2325 LN -
0.535.6210
5 Operation | 5.1 Attaching the medical device
16 / 28
5 Operation
Note
At the beginning of each workday, the water-conducting systems should be
rinsed for at least 2 minutes (without transmission handpieces being at-
tached) and if there is a risk of contamination from reflux or back suction, the
system may also need to be rinsed for 20 to 30 seconds after each patient.
5.1 Attaching the medical device
WARNING
Detachment of the medical device during treatment.
A medical device that is not properly locked can release from the MULTIflex
coupling during treatment.
▶ Before each use, check if the medical device is securely locked onto the
MULTIflex coupling.
NOTICE
Inaccurate coupling can destroy the high-pressure lamp or the LED of the
coupling or reduce its service life.
▶ Make sure that the turbine is accurately coupled and firmly seated on the
coupling.
▶
Mount the medical device accurately on the
MULTIflex (LUX) / MULTIflex LED coupling and push it backward until the
coupling audibly locks in the medical device.
▶ Pull on the medical device to make sure that it is securely affixed to the
coupling.
5.2 Removing the medical device
▶
Grasping the coupling, twist the medical device slightly and pull it off.
5.3 Inserting INTRA LUX head in shanks 2307 LN or
2320 LN
CAUTION
Loosening of the medical device during treatment.
If the head is not properly locked in place, it can fall out during treatment.
▶ Do not mount or remove the head while rotating. Before each treatment,
check that the head is firmly seated and that the clamping ring is tight.
▶
Rotate the clamping ring in the direction of the arrow to the stop.
▶
Insert the head to the stop. Make sure that the catches are properly seated.
▶
Rotate the clamping ring in the opposite direction (-> close) and tighten it.