Kathrein UAS 582, Руководство пользователя

Страница: 3 / 8

3 / 8
Cable connection
1. Loosen the Allen screws (S) at the rear end of the
cover until the cover can be unlocked by applying light
downward pressure ① ; remove cover ② .
If the feed system is not only exchanged but
a new antenna system is being installed,
proceed first as described in the section
“Aligning the satellite reception system” and
then return to “Cable connection”.
2. Mount the supplied F-type plug onto the Kathrein
cable types LCD 90, LCD 111A+, LCD 115A+ oder LCD
120A+ montieren and connect to the LNB (see Fig. 4).
3. When connecting the matrix and the LNB, make sure
the correct output is assigned (mark cables if neces-
sary).
4. It is important to ensure that the bending radius of the
corresponding cable is not undershot.
5. Lead the connected cable forwards and insert side-
ways into the cable fastening (see close-up in Fig. 5
below).
6. Slide on the cover until it fits into the groove and locks
in the bottom section. Tighten Allen screw (S).
Allen screw (S)
①
②
Fig. 3: Remove cover
6,5 mm
6,5 mm
flush
Fig. 4: Plug mounting
2 x
Fig. 5: Cable connection