Kathrein ARU 2401, Руководство пользователя

Страница: 114 / 146

114 of 146
Operating the Reader Using the ReaderStart Software
16.8.3 Change Reader Parameter
Change reader parameter allows to change all reader settings using their respective configuration IDs.
4
6
1
2
4 5
3
Fig. 12: Expert settings 2: change reader parameter
①
Parameter ID selects the parameter ID
②
Parameter
value
shows or sets the parameter value
The value is either decimal or hexadecimal, it is possible to switch between
dec and hex.
③
Active param-
eter set
shows the current active parameter set
④ Get
reads the value of the current parameter set of the reader and shows it at
②
⑤
Set writes the parameter value (
②
) into the selected parameter ID (
①
)
16.8.4 Select Filter Settings
By means of these settings, it is possible to filter certain tags, e.g. to only read tags with the defined data in the respec -
tive memory banks. It is possible to set up to 32 filters.
7
8
9
10
11 12
2
4 5
1
2
3
4
5 6
Fig. 69: Expert settings 2: select filter settings
① Filter selects a filter
② Target
selects the tag target session
► Make sure the target matches the session set in
⑲
Fig. 67
③ Action
selects the action; see also EPCglobal Gen 2 Specification
Tip
► To see the description of an action, hover over the
Action
field.
➯ 
The description of the action appears in the tooltip:
④ Memory bank selects the memory bank (RFU/EPC/TID/User)
⑤
Save select
filter data to
file
saves the select filter data to file
⑥
Load select
filter data to
file
loads the select filter data from file
⑦ On
activates or deactivates the select filter
⑧
Bit pointer sets from which memory address the filter compares the mask data