Katadyn Spectra Bimini 300, Инструкция по установке и эксплуатации

Страница: 30 / 88

30
3. When the Calibration Sequence is complete, press the
button in the upper left corner to return to the Main
Menu.
When prompted by the display, Click Save to make
sure that the Calibration is stored in the system
memory.
4. The Filter Condition has now been calibrated to match
your installation.
1. During the calibration sequence the system will automatically start, begin to make water for
several minutes and then shut itself down. Make sure that the filters have been replaced for
new, the strainer is clean, and all thru - hulls are open before proceeding.
2. Follow the steps in Figures 1 — 4 below to initiate the Calibration Sequence.
Sensor Calibration
Many of the settings on your system have been pre - calibrated during standard factory testing,
however, there are a few settings that will vary based on the installation, vessel, and other
onboard conditions. If the system has just been installed you must calibrate the Prefilter
Condition before proceeding.
This procedure does not need to be done with each filter change under normal operation, it
should ONLY BE DONE IF THE FILTER CONDITION WON ’ T RESET TO 100%
WITH NEW FILTERS AND A CLEAN/NEW STRAINER SCREEN.
Prefilter Condition Calibration
Fig. 1 Fig. 2
Fig. 3 Fig. 4