KASTOR SAGA-20PK KSIL, Инструкция по установке и эксплуатации

Страница: 42 / 75

42 / 75
2.7. The stove door and changing the opening direction Saga and JK
The opening direction of KSIL doors cannot be changed.
The opening direction of JK is changed by turning the door upside down.
The opening direction is changed by turning the door upside down.
•
Open the door and push the hinge pin out of the lower hole.
•
Pull the pin downwards out of the upper hole to release the door. Remember the washers.
•
Turn the door into the desired position.
•
Slip the hinge pin first into the sleeve's upper hole and the washers on top of the sleeve
onto the pin. (The risers on the pin must be at the lower end.)
•
Slip the door's upper hole onto the hinge pin above the sleeve.
•
Finally, guide the hinge pin into the lower holes of the sleeve and the door.
2.8. Grate
There is a grate in the heater's stove. Place it on brackets on the bottom of the stove.
2.9. General directions to prevent damage
When you bring the stove into the sauna, before you add the stones, burn a full load of wood in a
well ventilated sauna to burn off the last protective substances and harden the coating.
Kastor heater is ready to be used after burn-ins completed outdoors and indoors, and after
stones have been added.
Please read and follow the instructions below:
•
Remember to leave free air space to aid the burning process.
•
Do not heat immediately at full blast, if it is cold. The brick chimney might suffer damage.
•
Do not throw water directly at the glass door.
•
The stove’s operating life shortens, if it is constantly heated to a red glow.
•
The stove’s working life will be shortened significantly, if it is subjected to salt water. Note
that in close proximity to the sea even well water may contain salt.
•
Factors influencing the stove’s useful life are, among other things, how well its size is
suited to the sauna, the fuel used, how often it is used, failure to follow these instructions
and general carefulness.
•
Kastor stoves have been very carefully designed and tested. On the basis of our studies,
we at Helo Oy know that if the stove suffers damage in a very short time (e.g. the walls
split or burn through, the top burns through etc.), the stove has not been used according
to instructions. Helo Oy does not take responsibility for damage through failure to follow
the user’s manual.
3. Using the stove
3.1. Fuel
Use only untreated wood in Kastor stoves, preferably sturdy split logs of various woods, such as
birch or alder. The logs should at most be 38 cm long. Wet or foul wood does not heat very well.
It is not permitted to burn treated wood, wood with nails, plywood, plastic, plastic coated
cardboard or paper in this stove. Fluid fuels may not be used even while starting the fire, since it
might damage the grate. Do not burn full loads of very small wood such as shavings and
splinters, as they produce excessive heat for short durations.
The fuel logs must not be stored in the immediate vicinity of the stove. Remember the safety