15
Cod. 2050-0001 Rev 1.1
WARNING
The equipment must be accompanied by external pre-filter that can
guarantee dechlorination and filtration of raw water.
It’s recommended to use the filter PROFINE
®
BLUE Small
5.3
REPLACEMENT OF CARTRIDGE PROFINE FILTER
To replace the pre-filter follow these steps:
Turn off the machine by pressing the button
Turn used up cartridge ¼ " turn to the left and pull it out by pulling it down from the head.
Remove the protective cap from the new cartridge and write down the date of installation of the new
cartridge in the provided space.
Insert the new cartridge without forcing it in any way, making sure to enter the tabs in their own seats
in the head and turn it 90 ° to the right until it stops without forcing.
To facilitate the entrance you can moisten slightly the seals, placed on the cartridge, with water or
cooking oil.
The removed cap can be used to seal the used up cartridge.
Open the 10mm intermediate valve located in the outlet of the pre-filter head and
place it in a drain point, then open the tap located upstream of the machine. Allow
at least 20 liters of water to wash the new pre-filter and close the valve.
Turn on the machine by pressing the button
and carry the filter time reset of
the board out.
