LED4C11 MANUAL
2
SAFETY FIRST
Please read and follow these important instructions to help ensure your safety and the quality performance
of your Kasco equipment.
•
LEDC11 kit is 120Vac and MUST be plugged into a GFCI protected receptacle or GFCI protected field
terminal connections.
•
LEDC11 fixtures MUST be properly submerged (approximately halfway) to avoid overheating;
insuffi
-
cient submersion or operation out of water will damage fixtures and void warranty.
• Use caution when dealing with any electrical and/or moving equipment.
•
Under NO CIRCUMSTANCES should anyone enter the water with the electrical equipment plugged in
and/or in operation.
• Kasco WaterGlow lighting kits are intended for use with a Listed control panel having a GFCI protected
receptacle, or field wiring terminals and disconnect switch, or a timer with a disconnect for use with a
GFCI receptacle. They are intended to be mounted on a floating fountain or aerator for use in a natural
or man-made body of water to comply with NEC Article 682.
• Kasco WaterGlow lighting kits have not been evaluated for use in swimming pools, spas or stationary
fountains.
•
Use extreme caution around water, especially cold water, as in spring, fall, and winter, which poses a
hazard in and of itself.
• NEVER lift or drag the equipment by the power cords. If you need to pull the unit to the side of the pond,
use the anchoring ropes.
• Do not use boats that tip easily for lighting kit installation and follow all boating safety rules and regu-
lations, including wearing a PFD (Personal Flotation Device). Do not use waders in deep ponds/lakes or
ponds/lakes with drop-offs, drastic slopes, or soft bottom material.
• For more information regarding your control panel instructions, refer to your equipment owner’s manu-
al. A control panel must be installed a minimum of 5 feet (3m in Canada) from the body of water unless
separated from the body of water by a fence, wall, or other permanent barrier that will make the unit
•
Warning:
When using the universal mounting bracket assembly, ensure the WaterGlow fixtures are
mounted properly to provide cooling of the fixture. Typically, the bottom half of the fixture should be
submerged. Recheck the fixture elevation with the fountain/aerator in operation. Assembly to your
fountain/aerator float will be as illustrated on the next page. Make adjustment to the fixture elevation
to ensure the fixture is properly submerged when the fountain/aerator is in operation.
•
Many fountain/aerator floats will drop lower in the water when running.
Back to Contents