Kasco marine LED3S19, Руководство пользователя

Страница: 5 / 12

5
your LED light kit to your ield installed GFCI
protected outlet and timer.
Instructions For Mounting LED6S19
Instructions for attaching brackets on the loat prior
to mounting the light ixtures on 2 HP or larger Kasco
units.
Parts needed:
•
Lower loat brackets (6)
• 3/8” washers (3)
Part 1
Part 2
1. Turn the unit upside down. Loosen and remove the
3/8” nuts on the three 9” bolts that are closest to the
motor unit. Place 2 Lower Float Brackets(Part #1) and
one 3/8” washer(Part #2) on each of the 9” bolts over
the bottom screen clips and replace the 3/8” nut.
2. Arrange the brackets into the position shown and
tighten down the nuts. Once the brackets are secure,
turn the unit back into its upright position.
¼” Nut against the underside of the loat tab as shown
in Fig. 10. Tighten the nut until snug using the 7/16”
wrench.
Fig 10
lat washer
lock washer
1/4” nut
4. Adjust the angle of the light as desired and tighten
the ¼” x ½” bolts on the sides of the mounting bracket
until snug. For more uniform illumination, it is best to
have all three ixtures at the same angle.
5. Repeat steps 1 through 4 for the remaining ixtures.
Assembled light ixtures are pictured in Fig. 11. Note
the orientation of the lights and mounting brackets.
Fig 11
6. Using the cable ties, tie each ixture cord to bottom
leg of mounting brackets using the holes provided.
The will act as a strain relief and will keep the cord
from being damaged by the fountain and balance the
unit properly. Next, cable tie the main power cord to
the loat as shown in Fig. 12.
Fig 12
7. Upon installation of the assembled unit, connect