Karma REVERO 2017, Руководство пользователя

Страница: 89 / 168

88
GARAGE DOOR OPENER
Garage Door Opener
HOMELINK® TRANSMITTER
WARNING: Do not use this
HomeLink® transmitter with any
garage door that lacks safety stop and
reverse features. A garage door opener
which cannot detect an object in the path
of a closing door and then automatically
stop and reverse the door does not meet
current safety standards. Using a garage
door opener without these features
increases the risk of serious injury or death.
The HomeLink® universal
transmitter is built into the rear
view mirror and provides a convenient way
to replace up to three hand-held
transmitters with a single built-in device.
PROGRAMMING A DEVICE
WARNING: When programming
your HomeLink® transmitter, you will
be operating the garage door or gate. Be
sure that people and objects are out of the
way, to prevent potential harm or damage.
1.
Make sure the vehicle is in Accessory
mode.
2.
If you have previously programmed
your HomeLink® transmitter, proceed
to step 3. Press and hold the two outer
buttons for approximately 20 seconds.
When the indicator light (arrowed)
begins to flash, release the buttons. Do
not hold the buttons for longer than 30
seconds.
This initializes the HomeLink®
transmitter and erases previous
settings from all three channels.
Note:
Do not perform this step when
programming additional hand-held
transmitters.
3.
Decide which one of the three channels
you want to program.
4.
Position the end of your hand-held
transmitter 1-3 inches (25 - 75 mm)
away from the buttons.
5.
Simultaneously press and hold both the
mirror button you want to program and
hand-held transmitter button. The
indicator light will flash slowly and then
rapidly after the mirror successfully
receives the frequency signal from the
hand-held transmitter.
Release both buttons.
6.
Press and hold the programmed
garage door opener button and
observe the indicator lamp.
• If the indicator is continuous,
programming is complete and your
device should activate when the
garage door opener button is pressed
and held for approximately 1 to 2
seconds and then released.
• If the indicator lamp blinks rapidly for
two seconds and then glows steadily,
proceed with the following
instructions for Programming rolling
code device equipment.