6
English
Environmental protection
The packing materials can be recycled. Please
dispose of packaging in accordance with the en-
vironmental regulations.
Electrical and electronic devices contain valua-
ble, recyclable materials and often components
such as batteries, rechargeable batteries or oil,
which - if handled or disposed of incorrectly - can
pose a potential danger to human health and the envi-
ronment. However, these components are required for
the correct operation of the device. Devices marked by
this symbol are not allowed to be disposed of together
with the household rubbish.
Working with detergents may only be performed on
watertight surfaces with connection to the waste
water sewage system. Do not allow detergent to enter
waterways or the soil.
Notes on the content materials (REACH)
Current information on content materials can be found
at:
www.kaercher.de/REACH
Accessories and spare parts
Only use original accessories and original spare parts.
They ensure that the appliance will run fault-free and
safely.
Information on accessories and spare parts can be
found at
www.kaercher.com
.
Scope of delivery
Check the contents for completeness when unpacking.
The scope of delivery for your equipment version is
shown on the packaging. Please contact your dealer if
any accessories are missing or in the event of any ship-
ping damage.
Safety instructions
몇
CAUTION
●
Do not use the device when persons are in the vicinity
of the cleaning head.
●
Switch the high-pressure cleaner off and disconnect
the T-Racer from the high-pressure gun after finishing
cleaning work and before performing any work on the
T-Racer.
●
Do not trigger the high-pressure jet at the high-pres-
sure gun until the T-Racer is on the surface to be
cleaned.
●
Recoil danger. Keep proper footing and hold the high-
pressure gun and extension tube firmly.
●
Maximum water temperature 60°C (please observe
the instructions for your high-pressure cleaner).
Note
●
Be sure to always adhere to the safety instructions for
your high-pressure cleaner and the locally applicable
regulations and directives.
Symbols on the device
Device description
For the illustrations, refer to the graphics page
Illustration A
1
Extension tube
2
Rotor arm height adjustment
3
Casing
4
Bayonet connector with union nut
5
Handle
6
Surface cleaning foot button
7
Edge and corner cleaning foot button
8
High-pressure nozzle
9
Rotor arm
10
Front high-pressure nozzle
11
Skids
12
Rinsing nozzle
13
Rinsing function foot button
Extension tube installation
Note
Ensure that the device components are tightly connect-
ed on installation.
Illustration B
1. Plug the bayonet into the mounting.
2. Turn the extension until it latches into place.
3. Tighten the union nut.
Repeat the procedure for all further extension tubes.
Initial startup
Selection of the high-pressure nozzles
Using the appropriate high-pressure nozzles is a pre-
requisite for fault-free operation.
Note
These are to be selected according to the flow rate (l/
min). Information on the flow rate is provided in the op-
erating instructions or on the type plate of the high-pres-
sure cleaner.
Note
The yellow high-pressure nozzles are already fitted.
DANGER
Risk of injury! Never reach under the
edge of the T-Racer during operation
Cleaning type: Surface cleaner
Cleaning type: Edge and corner cleaning
Cleaning type: Rinsing function
HARD
For durable surfaces, e.g. tiles, concrete,
stone
SOFT
For sensitive surfaces, e.g. wood
Содержание T 7 Plus
