Kärcher SC 2, Инструкция по эксплуатации

Страница: 18 / 46

18 English
Note:
If you always use usual commercial distilled water it is
not necessary to descale the boiler.
As limescale builds up on the boiler walls, we recom-
mend to descale the boiler in the following intervals
(RF=reservoir fillings):
Note:
Please contact your Conservancy Board or the local
water supply company to inquire about the hardness of
your water.
 Disconnect the mains plug from the socket.
 Allow device to cool down.
 Remove the safety lock from the device.
Illustration
 Completely empty the steam boiler to remove exist-
ing water.
ATTENTION
Only use products approved by KÄRCHER to exclude
any damages of the appliance.
 Use KÄRCHER decalcifying agents for descaling.
Please follow the dosing instructions on the pack-
aging when preparing the descaler.
 Pour the descaling solution into the boiler and allow
it to react for approximately 8 hours.
 Completely empty the descaling solution after 8
hours. A small amount of the solution will remain in
the boiler. Therefore, you should rinse the boiler
two to three times with cold water to remove any
residues of the descaler.
Illustration
 Completely empty the steam boiler to remove exist-
ing water.
(Accessories - depending on scope of delivery)
NOTICE
The floor cleaning cloth and the cover for the manual
nozzle have been washed beforehand and can be used
immediately for working with the appliance. The micro
fibre cloths are not suitable for dryer.
NOTICE
When washing the cloths, observe the instructions on
the washing tag. Do not use any liquid softeners as this
will affect the ability of the cloths to pick up dirt.
 Wash the floor cleaning cloths and covers at a max.
temperature of 60 °C in the washing machine.
Often, failures have simple causes and you can do the
troubleshooting yourself using the following overview. If
you are in doubt or if the failure is not listed here please
contact the authorized customer service.
 Descale the steam boiler.
 Turn off the appliance.
 Fill the water reservoir
Steam switch is secured with the lock / child-proof lock.
 Move the selector switch for the steam volume to
the front.
 Press the steam gun until less water is emitted.
 Descale the steam boiler.
Subject to technical modifications!
Descaling the boiler
Degree of hardness ° dH mmol/l RF
I soft 0- 7 0-1,3 55
II medium 7-14 1,3-2,5 45
III hard 14-21 2,5-3,8 35
IV very hard >21 >3,8 25
Care of the Accessories
Troubleshooting
Long heating-up time
Steam boiler is decalcified
No steam
No water in the steam boiler.
Steam lever cannot be pressed anymore
High water output
Steam chamber too full
Steam boiler is decalcified
Technical specifications
Power connection
Voltage 220-240
1~50-60 V
Hz
Protective class I
Protection class IPX4
Performance data
Heating output 1500 W
Operating pressure max. 0,32 MPa
Heating time 8 Minutes
Steam volume
Continuous steaming
40 g/min
Steam push max. 100 g/min
Dimensions
Boiler capacity 1,0 l
Weight (without accessories) 3,1 kg
Width 254 mm
Length 380 mm
Height 260 mm