Kärcher Puzzi 8/1, Инструкция по эксплуатации

Страница: 9 / 36

English 9
1. Add defoaming agent (special ac-
cessory) to the wastewater contain-
er.
Operation
Switching on the device
1. Connect the mains plug.
2. Press the suction switch to switch on
the suction turbine.
3. Press the spray switch to switch on
the spray pump.
Cleaning mode
ATTENTION
Danger from cleaning solution
Risk of damage
Before using the device, check the ob-
ject to be cleaned for colour fastness
and water resistance in an inconspicu-
ous place.
1. Remove loose dirt from the object to
be cleaned.
2. Press the lever on the upholstery
nozzle to spray the cleaning solu-
tion.
3. Run over the surface to be cleaned
in overlapping paths. Pull the nozzle
backwards (do not push).
4. When changing the nozzle, the up-
holstery nozzle can be inserted into
the holder for accessories.
Switching off the device
1. Switch off the spray switch and the
suction switch.
2. Pull out the mains plug.
Empty the wastewater container
1. Switch off the suction switch and the
spray switch when the wastewater
container is full.
2. Remove the cover.
3. Remove the wastewater container
from the device and empty it.
Emptying the fresh water tank
1. Switch off the device.
2. Briefly operate the lever on the up-
holstery nozzle to relieve pressure.
3. Disconnect the upholstery nozzle
from the spray/suction hose.
4. Hang the suction hose in the fresh
water tank.
5. Press the suction switch to switch on
the suction turbine.
6. Suck the fresh water tank empty and
switch off the device.
7. Remove the cover.
8. Remove the wastewater container
from the device and empty it.
Flushing the device
1. Connect the upholstery nozzle to
the suction hose.
2. Connect the spray hose coupling to
the upholstery nozzle and latch into
place.
3. Pour approximately 0.5 gal (2 litres)
of tap water into the fresh water
tank. Do not add detergents.
4. Press the spray switch to switch on
the spray pump.
5. Hold the upholstery nozzle over a
drain.
6. Operate the lever on the upholstery
nozzle and flush the device for 1 to 2
minutes.
7. Switch off the device.
Each time after use
1. Flush the device.
2. Drain the wastewater container and
clean it under running water.
3. Empty the fresh water tank.
4. Clean the exterior of the device with
a damp cloth.
5. To avoid unpleasant smells, remove
all water from the device before long
downtimes.