Kärcher KM 85/50 W Bp, Оригинальное руководство пользователя

Страница: 18 / 336

-
4
Note: The hood is unlocked with the same
key as the main switch. The key can only
be removed if the hood is locked.
 Insert the main switch key in the hood
lock and turn it by 180°.
 Open the device hood.
 Secure the appliance hood to the hood
support to prevent it from closing.
 Remove hood support.
 Close cover.
 Close the device hood with the main
switch key.

DANGER
Risk of injury and damage! Do not use a
forklift to unload the appliance.
To unload the machine, proceed as follows:
 Cut plastic packing belt and remove foil.
 Remove the wooden blocks that secure
the wheels and raise the device from
the palette by hand.
 KM 85/50 W Bp Adv
KM 85/50 W Bp Pack Adv
Turn the push handle lock counter-
clockwise; lock is unlocked.

Remove the waste container.

Push appliance to the back onto the
push handle.

Clip side brush on to driver and screw
on.
 Tilt the appliance forward.
Please observe the following warning notes
when handling batteries:

Danger
Risk of explosion! Do not put tools or similar
on the battery, i.e. on the terminal poles
and cell connectors.

Danger
Risk of injury! Ensure that wounds never
come into contact with lead. Always clean
your hands after having worked with batter-
ies.

Danger
Risk of fire and explosion!
–
Smoking and naked flames are strictly
prohibited.
–
Rooms where batteries are charged
must have good ventilation because
highly explosive gas is emitted during
charging.

Danger
Danger of causticization!
–
Rinse thoroughly with lots of clear water
if acid gets into the eye or comes in con-
tact with the skin.
–
Then consult a doctor immediately.
–
Wash off the acid If it comes in contact
with the clothes.

KM 85/50 W Bp
 KM 85/50 W Bp Adv
Note: Recommended battery and charger,
see Accessories.
 Open the device hood.
 Secure the appliance hood to the hood
support to prevent it from closing.
CAUTION
Risk of damage. Remove battery bowden
cable from the holding plate.
1 Rating nut
2 Nut
3 Disc
4 Halting plate
5 Disc
6 Counter-nut
7 Fork head
8 Lever
Loosen the bowden cable:

Pull out the pin from the fork head and
lever.
 Loosen counter-nut.
 Take off the rating nut from the halting
plate.
 Set the battery to motor carrier.
 Secure the battery with the holder tape.
Replace Bowden cable:
 Remount the rating nut from the halting
plate.
 Tighten counter nut.
 Position the fork head on the lever and
slide and secure the pin through the
fork head and the lever.
Open the device hood.
Close device hood
Before Startup
Unloading
Install side brush
Batteries
Safety notes regarding the batteries
Observe the directions on the
battery, in the instructions for
use and in the vehicle operat-
ing instructions!
Wear an eye shield!
Keep away children from acid
and batteries!
Risk of explosion!
Fire, sparks, open light, and
smoking not allowed!
Danger of causticization!
First aid!
Warning note!
Disposal!
Do not throw the battery in the
dustbin!
Install batteries
18 EN