Kärcher G3200, Руководство пользователя

Страница: 16 / 32

16 English
17
Coupling plug (not for MX / CA)
18
Cap
19
Sealing ring (3 pieces, replacement for high-pres-
sure hose and high-pressure gun)
20
Water sieve
21
Bar cover
22
Spark plug wrench
23
Cleaning needle
24
Funnel
25
Engine oil bottle
26
Screw with snap ring and washer
27
Trigger
28
Pawl
29
Vibration damper
30
Union nut (high-pressure gun)
31
Thermostat valve
32
Water spigot
33
Union nut (water spigot)
34
Engine
35
Power switch
Safety devices
몇
CAUTION
Missing or modified safety devices
Safety devices are provided for your own protection.
Never modify or bypass safety devices.
Power switch
The power switch stops you from operating the device
unintentionally.
Trigger lock
Note
The trigger can be locked against unintentional opera-
tion by latching the pawl in the groove on the rear han-
dle of the high-pressure gun.
Locking the trigger:
1. Fold up the pawl on the trigger until it latches in the
groove on the rear handle of the high-pressure gun.
Illustration B
The trigger is locked.
Unlocking the trigger:
2. Disengage the pawl from the groove on the rear
handle of the high-pressure gun and fold it onto the
trigger.
The trigger is unlocked.
Thermostat valve on the pump
The thermostat valve opens when the maximum per-
missible water temperature is exceeded and discharges
the hot water to the outside.
Symbols on the device
Installation
For the figures, please refer to the graphics page.
Before initial startup, mount the loose enclosed parts on
the device.
Mounting the wheels
1. Position the wheel axle in the mount on the device
frame as shown.
Illustration C
2. Press the spring-loaded pin and push the wheel axle
into the mount until the spring-loaded pin engages in
the hole.
3. Install the second wheel in the same way.
Raising the handle
1. Unlock and raise the handle, see chapter Folding
the handle .
Installing the high-pressure gun holder
1. Install the high pressure gun holder on the left side
of the handle with the screw, snap ring and washer.
Illustration D
Installing the coupling plug on the water
spigot
1. Pull the cap out of the union nut on the water spigot.
Illustration E
2. Remove the water sieve from the cap.
3. Carefully fit the water sieve into the union nut on the
water spigot.
4. Screw the coupling plug into the union nut on the
water spigot.
Illustration F
5. Hold the square end of the coupling plug with an
open-end wrench and hand-tighten the union nut.
Note
Removal is performed in the reverse sequence.
Do not connect the device directly to the
public drinking water network.
Do not point the high-pressure jet at peo-
ple, animals, live electrical equipment or
at the device itself. Protect the device
from frost.
Risk of burns! Do not touch these hot
components.
Danger of poisoning! Never inhale the ex-
haust gases.