SmartVision3 - User Manual
Page 11 on 52
Use only the USB Type-C cable supplied with this device. You risk damaging the device if
you use a micro-USB cable.
To save energy, unplug the charger when not in use. Since the charger does not have an
On/Off button, you must unplug it from the power outlet to turn off the power. The device
must remain close to the outlet while charging.
Good to know: The autonomy of the SmartVision3 depends on the use you make of it. The more
you use the device, the faster the battery will drain. You can optimize battery usage by adjusting
certain settings such as screen brightness, standby time, activating power saving mode, closing
apps running unnecessarily in the background or deactivating Bluetooth and Wi-Fi if you don't use
it.
Wired charging
To charge the battery, connect the USB Type-C cable between the SmartVision3 USB connector
and the mains charger. Then plug the AC charger into a wall outlet. When the battery is fully
charged, disconnect the charger from the device.
Wireless charging
SmartVision3 is compatible with wireless charging. You can therefore charge the battery using the
wireless charger provided with the OMNI pack. Connect the USB Type-C cable between the USB
connector of the wireless charger and the mains charger and then plug the mains charger into a
wall outlet. Place the back of the SmartVision3 in the center of the wireless charging station. When
the battery is fully charged, remove the device from the wireless charging dock.
Precautions for wireless charging:
If you do not observe the precautions below, the device may not charge properly or heat up, or it
may damage the device and its motherboards:
Do not place the device on the wireless charging dock with a credit card or Radio
Frequency Identification card (RFID) (travel card or access card) placed behind it.
Do not place the device on the wireless charging dock when conductive materials, such as
metal objects and magnets, are placed between the device and the wireless charging dock.
Battery charging tips and precautions:
If the battery is completely discharged, you will not be able to turn on the device, even if the
charger is plugged in. Charge the battery for a few minutes before turning on the device.
If you use multiple apps simultaneously, network apps, or apps that require a connection to
another device, the battery will drain quickly. To avoid losing power while transferring data,
always use these apps when the battery is fully charged.
If you use a power source other than the charger, such as a computer, the charging speed
may be slowed.
The device can be used while charging, but in this case it may take longer to fully charge
the battery
The device and charger may become warm while charging. When using the wireless or fast
charging feature, the device may feel warm to the touch. This has no effect on the life of the
device or its performance, and is completely normal. If the battery temperature becomes
too high, the charging speed may decrease or the charger may stop charging.
Switch the phone on / off
To turn on your SmartVision3, long press the On/Off button located on the upper edge. When the
device vibrates, release the button. If the product does not turn on, check that the battery has
been properly charged. To switch off the device, long press the On/Off button located on the upper
edge. Then select the item “Power” then “Power off”.
