NanoParticle Nebulizer: Operation
Liquid NanoParticle Sizer User Guide
11
Version 1.0.1
Equipment You Need
To install the Liquid NanoParticle Sizer, you will require the following items:
▪
9/16 wrench.
▪
A length of ¼ inch OD tubing sufficient to reach from the instrument
to your waste drain (12 ft maximum length).
▪
A length of ¼ inch OD polyethylene tubing sufficient to reach from
the instrument to your air supply.
▪
For online sample introduction:
▪
A length of ¼ inch OD x 0.156” ID High Purity PFA tubing sufficient
to reach from the instrument to your water supply.
▪
PFA tubing flaring tool, tube gripper, and heat gun.
▪
Ultrapure Water supply. Note: Water pressure should be 20-70 psi at
100 ml/min.
▪
Conductive tubing for transporting the generated aerosol (shipped
with the LNS aerosol size spectrometer).
▪
A supply of clean, dry, compressed air at 2 slpm. Note: The air
pressure should be 50-60 psi.
▪
Access to a suitable liquid waste outlet.
▪
A clean tube cutter.
▪
120-240 VAC power at 50/60 Hz.
Note: No PFA tubing is supplied with the Liquid NanoParticle Sizer.
