Before you start to install the drive familiarize yourself with the
drive controls and connectors.
Front Panel
•
Headphone Jack:
For connection to headphone or powered
speakers.
•
Volume Control:
For controlling the volume of the headphones.
Moving it to the left reduces the volume, moving it to the right
increases the volume.
•
Emergency Disc Eject Hole:
For manual ejection of the disc in
case of emergency.
•
Drive Status Led:
When the tray or disc is being accessed, the
led shines or flashes orange. When a disc is loaded but not being
accessed the led is out. When an unreadable disc is loaded or
there is a hardware failure the led will blink.
•
Open/Close:
Pushing this button opens or closes the disc tray
Drive Features
DVD+ReWritable
HighSpeed
ReWritable
Headphone Jack
Audio Signal
Voltage Output
Max. 2V
Volume Control
Drive Status Led
Emergency Disc Eject Hole
Open/Close
Back Panel
•
Digital Audio:
For connection to a sound card that
supports the Sony/Philips digital interface (SPDIF) .
•
Analog Audio:
For connection to the analog stereo input of
a sound card.
•
Drive Jumper:
( IDE Master/Slave mode jumper) For
setting the drive as a master or slave. Factory setting is as a
Master.
•
Host Interface:
For connection to your computers
Primary or Secondary IDE connector via 40-pin IDE cable.
•
DC Input:
For connection to your computers power supply.
Uses DC+5volt and +12volts.
HOST INTERFACE ( ATAPI )
DIGITAL
AUDIO
DIG
GND
Use
CSEL
Slave
Master
ANALOG
AUDIO
DRIVE JUMPER
DC INPUT
+5V GND +12V
R GND L
1
39
2
40
5
4
