Kanga 8D Series, Руководство оператора

Страница: 63 / 76

63
TRACK CHAIN LINK REMOVAL
If traction between the drive wheel and track is lost, increase tyre pressure in 5psi stages to
compensate for wear. If traction is lost when the tyre pressure is set at 75psi, track chain links will
need to be removed to tighten tracks.
1. Use the
Track Removal Instructions
to undertake this operation.
2. Once track is removed, lay track on its side.
3. You will have to pick a spot and pry the L/H segment apart to allow you to insert a 6mm
locking bolt through the chain link. Then pry the R/H segment back as far as you can with a
screwdriver to expose 2 full side plates (4 x pins).
4. Use chain splitter or angle grinder to grind off 2 pins that are on the outside of the 4 pins.
Grind off these 2 pins to remove 1 x link. Use a pin punch to drive the pins out to release the
chain section.
5. Turn the track over and perform the same on the other side to release the track so it is no
longer joined.
6. Use Joiner Link (Part number DL-003251) to rejoin the chain, this has now shortened the
chain by one link. Turn track over and perform this to the other side.
7. Remove the 6m locking bolts on both sides, and then reinstall the tracks.
8. Once links are removed tyre pressure must be decreased.