MULTICAL® 803
82
Kamstrup A/S · Technical description · 5512-2360_A1_
GB
_02.2019
6.3
Module readings
The TECH loop includes a number of module readings which depend on the mounted modules. These readings are
described in the respective technical descriptions of the modules. Simple modules, however, only include the
primary reading “Type/Config. no.” (for module on slot 1: index number 2-101-00). If the calculator is not equipped
with a module, “Type/Config. no.” is displayed as “00000000”.
Note: Module readings can be empty due to delay or interrupted communication between calculator and module.
The heart beat indication shows that both calculator and display are active. See the beginning of this chapter for
more information about the heart beat and status indications.
Index number in
display
Display reading
Display reference
number
Type/Config no.
2-101-00 / 2-201-00
2-301-00 / 2-401-00
N
o
31
Firmware no./rev.
Firmware example:
13570301 = 1357 C1
2-101-xx / 2-201-xx
2-301-xx / 2-401-xx
1
N
o
32
Module serial number
Example:
No. 12345678
2-101-xx / 2-201-xx
2-301-xx / 2-401-xx
1
N
o
33
Primary address
2-101-xx / 2-201-xx
2-301-xx / 2-401-xx
1
N
o
34
8
M-Bus secondary ID
2-101-xx / 2-201-xx
2-301-xx / 2-401-xx
1
N
o
35
8
M-Bus enhanced
secondary ID
2-101-xx / 2-201-xx
2-301-xx / 2-401-xx
1
N
o
36
8
1
These readings depend on the module and are thus not fixed readings. The order of the readings may vary. That is
why the index number is set to “xx”. However, the reference number will remain the same.
8
For module 60 - LON FT-X3, the reference numbers 34, 35 and 36 will be used for displaying the module’s neuron ID
divided into three parts. The module’s neuron ID is displayed in decimal format on the display. The read values must
be converted from decimal to hexadecimal for use in the LON system.