Kamstrup IP201, Руководство по установке

Страница: 6 / 8

6 Kamstrup A/S • 5512937_C1_GB_05.2017
IP201
6 Localization of light-emitting diodes (extract of the module)
Action Wink Error
7 Status LEDs
The module has a number of light-emitting diodes. They are used for indicating the status and
service.
7.1 Action
The Action diode indicates network activity. During normal operation, this diode lights/flashes.
Turned off:
The module does not connect to the network. Check that the cable is
connected correctly.
Flashing: Data is detected on the network. (the faster the flashing, the more traffic).
Steady light: The module is connected, but there is no traffic on the network.
7.2 Wink
The Wink diode is used for indicating the module’s conditions in three situations:
Start-up:
The Wink diode is lit until a valid IP address is found.
Localization: The Wink diode flashes.
Service: By pressing the service button, the Wink diode is lit. The Wink diode is lit while
the module is in service mode.
7.3 Err
The Err diode is used for indicating irregularities.
Steady light:
The module has just started and is waiting for an IP address.
Flashing: The module has not yet recognised the unit in which it is mounted (the host)
Turned off: Normal situation.