Kampmann Katherm QK 190, Инструкция по сборке, установке и эксплуатации

Страница: 44 / 52

Katherm QK
Assembly, installation and operating instructions
44
11.2 KaControl faults
Code Alarms Priority
A11 Faulty control sensor. 1
A12 Motor fault. 2
A13 Room frost protection. 3
A14 Condensation alarm. 4
A15 General alarm. 5
A16 Sensor AI1, AI2 or AI3 faulty. 6
A17 Unit frost protection. 7
A18 EEPROM error. 8
A19 Offline slave in the CAN bus network. 9
Tab. 10: KaControl unit alarms
Code Alarms
tAL1 Temperature sensor in the KaController faulty.
tAL3 Real-time clock in the KaController faulty.
tAL4 EEPROM in the KaController faulty.
Cn Communication fault with the external control.
Tab. 11: KaController alarms
IMPORTANT NOTE!
Important note!
More information on control settings can be found in the separate KaControl SmartBoard user manual.
11.3 Start-up after rectification of fault
After correction of the fault, carry out the following steps for recommissioning:
1. Make sure that all maintenance covers and access openings are sealed.
2. Switch off the unit.
3. Acknowledge the fault on the controller, if necessary.