4
.
2.42
Katherm QE –
Tangential fan convection with electric heating element
Ready-to-install convector-based floor trenches
Assembly and installation instructions
2. Safety Information
Make sure that installation, assembly and maintenance work on electrical units is only performed
by a qualified electrician (in compliance with national regulations).
Wiring should comply with applicable national regulations and provisions laid down by regional
electricity providers. Use this heater only as described in this manual. Any other use not
recommended by the manufacturer may cause fire, electric shock, or injury to persons.
There is a risk of fatal injury if wiring is not correct or wires are crossed! All parts of the system
should be disconnected from the power source before commencing with wiring or maintenance
work and should be prevented from accidental re-connection! Only connect the wiring to fixed
cables.
Read all instructions before installing or using this heater.
IMPORTANT INSTRUCTIONS:
• Disconnect all parts of the system that are being worked on.
• Ensure that the system cannot be accidentally re-connected!
• Before commencing the installation/maintenance work, wait until the fan has come to a
standstill once the unit has been switched off.
•
Caution!
This heater is hot when in use. To avoid burns, do not let bare skin touch hot
surfaces. Keep combustible materials, such as furniture, pillows, bedding, papers, clothes etc.
and curtains away from the heater.
A heater has hot and arcing or sparking parts inside.
Do
not use it in areas where gasoline, paint, or flammable
vapors or liquids are used or stored.
• Extreme caution is necessary when any heater is used by or near children or invalids and
whenever the heater is left operating and unattended.
• Do not operate the heater after it malfunctions. Disconnect power at service panel and have
the heater inspected by a reputable electrician before reusing.
• Do not use outdoors.
• Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may
cause an electric shock or fire, or damage the heater.
• To prevent a possible fire, do not block air intakes or exhaust in any manner.
• This heater may include an audible or visual alarm to warn that parts of the heater are getting
excessively hot. If the alarm sounds (or illuminates), immediately turn the heater off and
inspect for any objects on or adjacent to the heater that may have blocked the airflow or
otherwise caused high temperatures to have occurred. DO NOT OPERATE THE HEATER WITH
THE ALARM SOUNDING (OR LLUMINATING).
• Contractors must have adequate knowledge, obtained in their training, of:
• Safety and accident prevention regulations
• Guidelines and recognised technical regulations, i.e. ANSI/NFPA
• Technical wiring regulations (TABs) issued by the regional electricity providers
• SAVE THESE INSTRUCTIONS
Modifications to the unit
Do not undertake any modifications, renovations or additions to the Katherm QE without
discussing them with the manufacturer, as this could impair the safety and operation of the unit.
Do not undertake any work on the unit that is not described in this manual. On-site systems and
cabling must be suitable for connection to the intended system! Errors caused by connection or
modifications can lead to the unit being damaged! The manufacturer is not liable for any
damage caused by the wrong connection and/or improper handling.
Non-adherence to these regulations and the operating manual can lead to malfunction of the
unit with consequential damage and resulting danger to personnel. There is a danger of fatal
injury caused by wires being crossed due to incorrect wiring!
The floor trench has openings provided for the installation of a potential compensation line.
Содержание Katherm QE
Страница 19: ......
