clock thermostat, type 30056/146910
Page 15
6. Setting of functions
By pressing „PROG“ for 6 seconds you reach a menu which
you can set various basic functions in. The function is
indicated in the left part of the display and the pertaining
value respectively the position is indicated in the right part of
the display. The value can be changed with + and - keys.
You reach the next choice with „SET“. If you confirm the last
function with „SET“ the thermostat goes back to the
operating mode out of which the menu „Setting of functions“
has been polled. The individual functions have the following
meaning:
MO DI MI DO FR SA SO
Text
Basic setting
Limits/
Alternative
SEnS (Sensor alignment)
0.0 K
± 3.0K
Please do not align sensors immediately after installation
of the thermostat. as you need temperature values which
do not change too much any longer. Moreover a sensor
alignment should be done at normal ambient
temperatures (approx. 20 °C).
In order to proceed with a correct sensor alignment, the
actual temperature indicated by the thermostat as well as
the temperature at the sensor should be known
(temperature at the sensor must be measured by an
appropriate appliance). The difference between these two
values can be set within limits of ± 3,0K in menu point
SEnS.
Example:
The thermostat indicates 20,7°C.
The thermometer indicates 19.9 °C at the sensor.
The thermometer indicates 19.9 °C at the sensor.
H C (Heating / Cooling)
HE (heating)
Co (cooling)
In the mode „heating“ the controlled relay is indicated by
an arrow upwards in the left part of the display. In mode
„cooling“ the relay is indicated by an arrow downwards.
2PPu (On/Off /Pulse)
2-P (On/OFF)
PuL (Pulsing)
Changing the control function from On/Off to pulsing
leads computing with the appropriate parameters. These
are indicated bold print in menu point „setting of
parameter“. If necessary these values have to be
changed as described before.
