Kampa Geyser, Инструкция по установке и эксплуатации

Страница: 13 / 144

4445103340 13
Setting up the water heater
!
1. Place the appliance on a surface that meets the
above requirements.
2. Straighten out all hoses to make sure no kinks
or twists remain.
3. Attach the 12 V DC cable of the water pump
and the water hose to the appliance (see
fig.
3
, page 4).
4. Attach the gas hose to the appliance (see
fig.
5
, page 4).
5. Attach the other end of the gas hose to the gas
regulator (see fig.
6
, page 5).
6. Connect the gas regulator to the gas cylinder
following the manufacturers instruction.
7. Check that all connections are tight.
8. Turn on the gas regulator.
!
9. Check all connections for gas leaks:
– Coat all connections, using soapy water.
– If bubbles appear, immediately turn off the
gas regulator and re-tighten the connection
before re-testing.
– If bubbles appear again, do not continue to
use the appliance. Contact an authorized ser-
vice agent.
10. If no leaks are detected, turn the regulator
valve to the “OFF” position.
11. Swing the water outlet tap away from its stor-
age position to the side of the appliance (see
fig.
4
1. , page 4).
For use of the shower head:
Attach the shower head and hose assembly to
the appliance (see fig.
4
2. , page 4).
12. Check that the power switch at the rear of the
appliance is in the “OFF” position. Connect
the 12 V DC cable to the appliance and then
connect the 12 V plug to a suitable DC power
source (see fig.
7
, page 6).
Using the water heater
Requirements for operation
The following equipment is not supplied and must
be provided by the user:
• Butane or propane gas cylinder
• Gas regulator (supply pressure: see chapter
“Technical data” on page 17)
• Gas hose (length: max. 1.5 m)
• 12 V DC supply (e.g. by a vehicle, mains adapter
or battery pack)
• Clean water supply
Gas regulator and gas hose have to be CE
approved and fulfill the national safety require-
ments. In case of questions, contact your retailer or
gas supplier.
Switching on
!
!
I
WARNING! Fire hazard
The location for setting up the water
heater has to meet the following require-
ments:
• outdoors only
• open, well-ventilated area which is
protected from direct winds
• placing surface for the water heater
– out of heat-proof, non-combustible
or non-flammable materials
– standing level on or above the
ground
• solid, stable and flat level
WARNING! Explosion hazard
Do not try to detect gas leaks using a
flame or a pilot light.
WARNING! Fire hazard
• Make sure that all air inlets and
exhausts are kept free from obstruction
and closure.
• The appliance must be operated no
closer than 800 mm to the sides and
800 mm above all combustible sur-
faces, fabrics, flammable materials and
persons.
CAUTION! Health hazard
Do not use water direct from rivers, lakes
or the sea as inlet water.
NOTE
The heater will extinguish if used in a
wind speed above 10 kph.