Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don’t change the page numbering. Keep the
language integrity.
Print only what is inside the frame.
13
FT 37999 - 150821
Assembly page 13/16
Fax +32 2 359 95 50
CLEANING AND MAINTENANCE
•
Make sure to clean the appliance after each use!
•
Switch the appliance off by putting the knobs of the control panel into
the OFF position. Before cleaning, unplug the appliance from outlet and
allow it to cool down completely.
•
The tray and basket can be cleaned in hot water with dish soap, or in
the dishwasher.
Do not use metal kitchen utensils or abrasive cleaning
materials to clean them, as this may damage the non-stick coating.
Rinse and dry thoroughly after cleaning.
Inside cleaning
•
Wipe cavity with a damp cloth or sponge. Dry with a paper towel. To
remove baked-on food, pour a little cooking oil on the food and allow it
to stand for five to ten minutes. This should soften the food and allow it
to be removed with absorbent paper toweling or a soft cloth. The non-
stick coating on the cavity walls shall enable an easier cleaning.
•
Clean the inside of the glass door with a damp, soapy cloth. If the glass
has stubborn stains, open the door and cover the inside of the door with
a few damp paper towels. Leave for a few minutes, then remove the
towels and wipe the door clean. Never use sharp utensils as scratching
may weaken the glass and cause it to shatter.
•
Never use abrasive products in the cavity!
•
Never immerse the appliance in water and make sure that no water or
moisture penetrates into the appliance except the cavity.
•
Make sure no water comes on the door when it is still hot.
Outside / outside door cleaning
•
Wipe clean with a damp sponge or cloth. Wipe dry.
•
NEVER use steel wool, metal scouring pads or abrasive cleaners, as they
may damage the finish.
Any other servicing should be performed by an authorized service
representative.
DO NOT IMMERSE THE FRYER IN WATER OR ANY OTHER LIQUID!
