Kalmar Ottawa t2, Руководство по обслуживанию, Страница: 29 / 262

20 0.4 Preventive Maintenance Technique – C. Preventive Maintenance
Maintenance Manual Ottawa T2 4x2
Inspect Platforms — Inspect the platforms for proper
mounting and the absence of cracks and trip points.
Check Frame for Cracks — Inspect frame rails and cross-
members for cracks and bending.
Check Mud Flaps/Fenders (if applicable) — If equipped
with mud flaps and/or fender, inspect these items for proper
mounting and damage.
Change Hydraulic System Filter — Remove and replace
the hydraulic filter.
Check Hydraulic Fluid Level — Start engine, raise and
lower the boom two to three times to ensure that system
components are filled. Lower boom to full down position,
shut off engine and check fluid level on tank gauge. Fill as
necessary.
Change Hydraulic Fluid — Drain hydraulic tank and refill
with Dexron III automatic transmission fluid.
Clean Hydraulic Tank Vent — Remove any dirt collecting
around vent and ensure that vent is clear.
Check Cab Hinge Pins and Bushings — Inspect pins and
bushings for wear or damage.
0.4.7 Lubrication
page –
Maintenance
Check/Lubricate Rear Door Rollers — Inspect upper roll-
ers. Replace if binding or damaged. Lubricate.
Check/Lubricate Steering Slip Joint — Inspect slip joint
for wear or damage. Lubricate with lithium grease.
Check/Lubricate Steering U-Joints — Inspect U-joints
for wear or damage. Lubricate with lithium grease.
Check/Lubricate All Steering Lube Points — Inspect
king pins, tie rod ends and drag link ends for wear or dam-
age. Lubricate with lithium grease.
Check/Lubricate Slack Adjusters — Inspect brake slack
adjusters for wear or damage. Measure the brake actuator
stroke. If this measurement exceeds the component manu-
facturer's recommendation check brake lining and adjuster
to determine which is the cause of the excessive stroke and
repair as necessary.
Check/Lubricate Driveline U-Joints — Inspect driveline
and U-joints for wear or damage. Lubricate with lithium
grease.
Clean, Check Adjust and Lube 5th Wheel Jaws — Re-
move dirt and excessive grease from the 5th wheel jaws.
Using a 5th wheel jaw gauge measure the free play. If free
play exceeds 1/8" (3.175 mm) determine the cause of the
excessive play and either repair or replace the jaws per the
component manufacturer's recommendation.