KVAULT ODD Replacement
December 2020
101-0269-00 Rev 2
Page 22 of 24
2.
With the disc in the drive, tighten up the loose screws in the
assembly. Avoid applying any pressure to the brackets.
Tighten the screws in the following order:
1) Front 2.5mm hex screws x4 (Verify alignment markings made
earlier are close to their marked positions.) See Figure 3324.
2) Base 2.5mm hex screws x 4. See Figure 3223.
3) Top of ODD 1.5mm hex screws with washers x 2 (gently tighten).
See Figure 3021.
3.
With all the screws secured, carefully remove the disc from the
assembly.
Reinstall the Cables
1.
Route the cables through the ODD bracket openings as shown in
Figure 35:
Figure 35
2.
Connect the cables to the ODD assembly.
1) SATA cable to the rear of the Optical Drive
2) Motor cable to the mating cable from the main assembly
3) Sensor cable to the Sensor PCB from the main assembly. Be
careful not to apply too much force.
Figure 36
3.
Secure the cables with a tie-wrap to the drive bracket base.