4
1. Do not store spare liquid propane gas cylinder under or near this appliance.
2. Never fill the cylinder beyond 80 percent capacity
3.
Liquid propane cylinder must be fitted with an OVERFILL PROTECTION DEVICE (OPD).
4. The size for 20Ibs LP gas cylinder is 12.2 inches in diameter and 17.9 inches tall
5. If the appliance is not in use, the gas must be turned off at the supply cylinder.
6. The cylinder used must include a collar to protect the cylinder valve.
7. Other cylinders may be acceptable for use with the appliance provided they are compatible
with the appliance retention means and accompanied by illustration(s) depicting the cylinder
mounted to the appliance utilizing the cylinder retention means and the point of contact
between the cylinder and the retentions means.
8. The cylinder needs to be constructed and marked in accordance with the
Specifications for
LP gasCylinders of the U.S Department of Transportation (
D.0.T} or the standards for
Cylinders, Spheres
and
Tube for Transportation of Dangerous Goods and Commissions,
CNA/CSA-B339 as applicable. 10.Place dust cap on cylinder valve outlet whenever the
cylinder is not in use. Only install the typeof dust cap on the cylinder valve outlet that is
provided with the cylinder valve. Other types of caps or plugs may result in leakage of
propane.
Before Lighting
Read instructions before lighting.
lnspect the gas supply hose prior to turning on the gas. If there is evidence of cut, wear or
abrasion, it must be replaced prior to use.
Only the pressure regulator and gas hose assembly supplied with this appliance should be used.
Screw the regulator onto the gas cylinder. Leak check the hose and regulator connections with a
soap and water solution before lighting the appliance.
Open the grill lid during lighting.
For
MAIN BURNER
, push down and turn the control knob anticlockwise to HIGH (+), and press the
IGNITE (
) for 2-3 seconds until the burner ignites.
For
INFRARED REAR BURNER
, push down and turn the control knob anticlockwise to HIGH (+) and
press the IGNITE (
) FOR 2-3 seconds, when the burner ignites, keep pushing down the control
knob for 10 seconds until the flame stable.
If the ignition does not ignite, turn the control knob OFF and wait for 1 minutes and repeat
ignition.
