7
2
Montage instructies
ATTENTION: All parts have to be mounted maintenance friendly.
All parts have to be accessible at all times for the maintenance
service !!!
2.1
Gas tap
The gas control system with burner have to be connected behind a gas
tap, which at all times can be operated.
2.2
Electric point
A electric point 230 V with edge ground must be foreseen in case of an
appliance with a radio remote control.
2.3
Flexibele connection of gas control unit to burner
Because of sound resonance in the flexible tube (from gas control unit to
burner) this tube has to be placed so that the there is no bend smaller
than 5 cm in the tube. However it is allowed to make 1 rectangular kink
at the beginning and 1 rectangular kink at the end.
2.4
Assembly of the manual gas control unit
The gas control unit has to be connected to the gas tap (not included) as
following:
•
Connect the gas supply to the gas control unit.
•
Test leak tightness of the system by means of soapsuds or leakage
testing spray.
•
Check the protection system by activating the security; the appliance
should go out.
2.5
Aassembly of the ultrasonic gas control unit
The appliance is standardly delivered connected to the gas control unit
and has to be connected to the gas tap (not included) as following:
•
Connect the gas supply (12 mm) to the gas control unit (12 mm-
clamp).
•
Test leak tightness of the system by means of soapsuds or leakage
testing spray.
•
Check the protection system by activating the security; the appliance
should go out.
8
Assembly instruction electric wiring
This remote control is mains independent. The system runs on batteries.
Insert the accompanying 9V block battery into the small transmitter.
Insert the 4 accompanying 1.5V penlight batteries into the battery
compartment of the receiver: please pay attention to the correct polarity
! See picture below.
The receiver is to be connected to the plugs on the gas control system by
means of the two flat connectors. The different size of the plugs prevents
an erroneous connection.
ATTENTION: This receiver has to be mounted outside of the
burner’s radiation area, because of the sensitiveness of the
electronics to heat radiation !
2.6
Assembly of the radiografic gas control unit
The appliance is standardly delivered connected to the gas control unit
and has to be connected to the gas tap (not included) as following:
•
Connect the gas supply to the gas control unit.
+
+
