21
4.3
Appliances with radio remote control
Take the battery-protection strip out of the manual transmitter and check
that the battery is still correctly positioned between the two contacts.
Plug into the electric socket and turn on the gas tap.
4.3.1
Lighting the burners
When the Big flame (Figure 14 no. 1) and the “Off” knob (no. 3) are
pushed in simultaneously (two-knob ignition!!), after a few seconds the
ignition will automatically start sparking. When the pipe and the gas
control unit are filled with gas, a pilot light will appear and the sparking
will stop. If the sparking does NOT
stop, there can only be two reasons for
this: the gas supply is still closed off
(no pilot light can be seen); in this
case turn on the gas tap - or the plug
is not pushed into the electric socket
correctly (there is a pilot light, but the
ignition keeps on sparking), then the
plug has to be turned round in the
electric socket (NL) or the L and N
wires need to be swapped over in the
black receiver box (BE). When the pilot
light is burning, the main burners will
start with a large flame and are then
continuously adjustable between maximum and minimum. You can adjust
the burners higher and lower with no. 1 and no. 2.
Resetten the appliance
If still no flame is detected after 30 seconds of
sparking, the automated burner unit safety-lock
will be activated. You can reset the automatic
burner unit by means of the remote control and/or
a reset knob on the automatic burner unit itself.
(This procedure may have to be repeated several
times when the appliance is first used or if it has
been out of use for an extended period).
I On the remote control you then press in the
“small flame” and “X” simultaneously (1) and
then immediately press “X” (2) again. (see
Figure 15).
1
2
Figuur 15 resetten
1
2
3
Figure 14 resetting
22
II If the automatic burner unit (Figure 16) is accessible, this can be
reset by pressing in a reset knob (3). You can see that this is locked
by the red lamp (3).
After the reset cycle, lasting about 10
seconds, you can re-start by
simultaneously pressing the ON and OFF
knob.
4.3.2
Extinguishing the burners
To completely extinguish the fire, press the OFF knob (Figure 14 no. 3)
on the transmitter, and the main burners as well as the pilot light will go
out completely.
If the electricity supply is interrupted, the fire will also go out.
If you are going to be away for an extended period, it is advisable to turn
off the gas supply to the appliance.
3
Figure 16 resetting
