KAL-FIRE Fera 105, Инструкция по установке и эксплуатации, Страница: 16 / 27

31
Now release the knob (1). If the pilot light does not keep burning,
wait for 3 minutes and then repeat the above steps.
Now turn the knob (1) fully in the opposite direction, as far as the
position with the “big flame”; now you can adjust the flames to the
desired size, by means of the right-hand knob (2).
3.1.2 Extinguishing the burners
The burners can be extinguished as follows: turn the ignition knob (1)
a quarter turn to the left as far as the “pilot light” position. The
burners will now be extinguished, however the pilot light will stay
alight. The burners can be re-ignited by turning the knob back to the
position with the “flames”.
If you do not wish to use the appliance over an extended period of
time, you can turn the knob (1) all the way back to the symbol “
z
”,
which will also extinguish the pilot light, at the same time you can
also turn off the gas tap.
32
3.2 Appliances with ultrasound remote control
3.2.1 Lighting the burners
Make sure the gas tap is turned on. The main burner in the fire is
ignited by a pilot light, which in turn is ignited by a piezo element.
Once the pilot light is lit, it heats up a thermocouple which creates a
small flow. This flow holds the gas valve open. Should the pilot light
go out, no gas can keep flowing. This means you can be sure of safety
at all times. The ignition takes place as follows: (see Figure 12)
Turn the ignition knob (3 in the above figure) to the “pilot light”
position (small flame) and press in. Gas will now flow to the pilot light.
Keep the knob pressed in, and turn it to the left, “
’
” position; you will
now hear the piezo ignition clicking and see a spark jump over to the
pilot light, keep this knob pressed in until the pilot light is burning
steadily. (This can take longer straight after mounting because the
gas pipe still has to fill with gas).
When the pilot light is burning, keep the knob (3) pressed in for
approximately another 20 seconds, otherwise repeat the above
operation.
Now release the knob (3). If the pilot light does not keep burning,
wait for 3 minutes and then repeat the above steps.
Figure 12: Ultrasound remote control
3 4
5