KAKA Industrial BS-75G, Инструкция по сборке и эксплуатации, Страница: 6 / 25

Encl.2.
7.3 BAND ASSEMBLY
Remove the bow guard 47 by unscrewing the screws 125 and the hand wheels 50 (DRAW.7
ENCL.6). Fit the band by inserting it first between the bearings of the blade guide heads and then
on the two pulleys, tighten the blade slightly by means of the hand wheel 43 (DRAW.5 ENCL.5)
and replace the bow guard. Check that the band is fitted with the correct direction of teeth, as
shown in drawing 8 enclosed document 6. Make sure that the band type (dimensions 2060×20×0.9)
and its teeth pith are suited to the material to be cut.
7.4 ELECTRICAL CONNECTION TO THE MAINS
Install a differential thermomagnetic switch with characteristics suited to the mains.
Make sure that the power supply voltage corresponds to the voltage on the motor plate. Connect
the cable to the power supply line observing the color codes of the individual wires, pay particular
attention to the earth wire. Connect the machine, make sure that the rotation of the circular blade
is in the direction shown by the arrow on the guard.
7.5 CUTTING COOLANT
For the cooling of the circular blade
，
fill the tank with emulsible oil obtained from a mixture of
water and AGIP ULEX 260 EP oil with a percentage of 5-7%
8. MACHINE START UP AND OPERATION
8.1 DEVICES AND THEIR LOCATION
(The location of the devices described is shown on the installation plan Encl.2)
Code
203 LOCKABLE MAIN SWITCH
Code 55 START-STOP MICROSWITCH: situated inside the handle located at the end
of the control lever and has safety release action.
Code 77 ELECTRIC PUMP
Code 45 CUTTING ANGLE DEVICE: to check that cutting inclination is as required
Code 5 LOCKING VICE
Code 91 BAR STOP
Code 94 CONTROL LEVER WITH HANDLE
8.2 TOOLS SUPPLIED
1 Allen wrench size 3
1 Allen wrench size 5
1 Allen wrench size 6
1 Allen wrench size 8
1 Allen wrench size 10
8.3 OPERATION
CHECKES TO CARRY OUT BEFORE EACH CUT
A Tension the band by rotating the hand wheel 43 to the end of stroke (mechanic stop)