KAESER M122, Руководство по обслуживанию

Страница: 109 / 348

10.3.3.3 Fuel filter maintenance
Fig. 45 Fuel filter maintenance
1
Filter holder
2
Filter cartridge
3
Turn in this direction to unscrew the filter cartridge.
1. Place a container beneath the fuel filter.
2. Use a filter wrench to loosen then unscrew the micro-filter cartridge. Collect any escaping fuel.
3. Clean the sealing faces of the micro-filter cartridges and the opposite site of the filter mount
with lint-free cloth.
4. Mount the micro-filter cartridges on the filter mount:
■ Moisten the rubber seals of the filter mount and the sealing faces of the new micro-filter
cartridges with some fuel.
■ Manually screw the micro-filter cartridge to the filter mount (clockwise), until seal is tight.
■ Continue to manually turn until the micro-filter cartridges are seated tightly (½ to ¾ turn ap‐
proximately).
5. Reconnect the batteries.
6. Close the access door.
The fuel system must be bled after the filter cartridge has been changed.
Dispose of fuel and any materials and components contaminated with it in accordance with
environmental protection regulations.
Starting the machine and performing a test run:
1. Switch the machine on and run it in IDLE mode for approx. 1 minute.
2. Shut down the machine.
3. Open the right-hand access door.
4. Visually check the fuel system for leaks.
5. Tighten all fittings.
6. Close the access door.
Further information The engine service manual provides further information on fuel system maintenance.
10.3.4 Checking the engine oil level
The engine oil is indicated by a dipstick in the oil sump. The oil level should ideally be between the
two marks on the dipstick. The oil level should not be allowed to fall below the minimum level.
10 Maintenance
10.3 Engine maintenance
No.: 9_6974 20 E
Service manual Portable compressor
M122
97
RAMIRENT