KAESER KOMPRESSOREN SX, Руководство по обслуживанию, Страница: 43 / 122

6 Installation
6.1 Safety
Follow the instructions below for safe installation.
Warning instructions are always given before a potentially dangerous action.
Basic safety instructions
1. Follow the instructions in chapter 3 'Safety and Responsibility'.
2. Installation work may only be carried out by authorized personnel.
3. Before switching on, make sure that:
■ no one is working on the machine,
■ all access doors and panels are closed and secure.
Working on live components.
1. Work on electrical equipment may only be carried out by authorized electricians.
2. Switch off and lock out the supply disconnecting (isolating) device and check that no voltage is
present.
3. Check that there is no voltage on floating relay contacts.
Working on pressure systems
1. Close shut-off valves or otherwise isolate the machine from the compressed air system to ensure
that no compressed air can flow back into the machine.
2. Vent all pressurized components and chambers completely.
3. Check all hose couplings in the compressed air system with a hand-held pressure gauge to en‐
sure that they all read 0 bar.
4. Do not open or dismantle any valves.
Working on the drive system
1. Switch off and lock out the supply disconnecting (isolating) device and check that no voltage is
present.
2. Do not open the cabinet while the machine is switched on.
Further information Details of authorized personnel are found in chapter 3.4.2.
Details of dangers and their avoidance are found in chapter 3.5.
6.2 Reporting Transport Damage
1. Check the machine for visible and hidden transport damage.
2. Inform the carrier and the manufacturer in writing of any damage without delay.
6.3 Making the Compressed Air Connection
Precondition The compressed air system is vented completely.
6 Installation
6.1 Safety
9_6919 04 E
Service Manual Screw Compressor
SX SIGMA CONTROL BASIC
33