Deactivate/activate the auto start function
1. Use the «Up» or «Down» keys to select the
Autostart: line.
6 . 1 b a r
0 8 : 1 5 A M
8 0 ° C
Header
5.4 Compressor start
Menu
▶1 Compressor on
Active line
▶2 Compressor off
·········
Autostart:
☐
Auto start deactivated
Target
12s ¦
Actual
0s
Set/expiring delay time
·········
2. Press «Enter».
The check box
Autostart: will flash.
3. Press «Up» key.
The check box
Autostart: is deactivated.
4. Press «Enter».
The
Autostart: function can be activated in the same manner.
The setting is applied.
5. Press «Escape» repeatedly to leave this menu.
Result Auto start after a power failure is deactivated.
8.7 Control modes
In type SXC compressors it is not possible to set the control modes since there is no IDLE
operating point. All menus connected to it are then not available.
The controller is provided with various control modes that can bring about varying capacity utilisa‐
tion depending on machine application. Chapter 5.8 provides a comprehensive description of all
control modes.
8.7.1 Setting the control mode
These control modes are possible:
■ DUAL
■ QUADRO
■ VARIO
■ DYNAMIC
■ Continuous
■ The standard setting of the control mode depends on the machine type.
■ The machine-dependant venting phase between the LOAD and READY operating modes
ensures load changes at minimum material stresses.
Precondition Access level 2 is activated.
8
Initial Start-up
8.7
Control modes
No.: 9_9450 12 E
User Manual Controller
SIGMA CONTROL 2 SCREW FLUID ≥5.0.X
105
