KAESER KOMPRESSOREN M170, Руководство по обслуживанию

Страница: 121 / 280

Cleaning the air filter:
1. Open both doors.
2. Release the retaining clip. Lift off the cap and extract the element.
3. Carefully clean the inside of the housing, the cover and sealing faces with a damp cloth.
4. Cleaning the filter element:
■ Use dry compressed air (≤ 5 bar!) at an angle to blow dust from the element from inside to
outside until no further dust develops.
■ The blast pipe must be long enough to reach the bottom of the element.
■ The tip of the blast pipe must not touch the element.
■ Cleaning sealing faces.
5. Inspect the element carefully for any damage.
Damaged filter element: replace filter element.
6. Insert the cleaned or new filter element into the filter housing. Make sure it is properly in place
and sealed by its gaskets.
7. Replace the cap and secure with the clip.
Resetting the maintenance indicator:
➤ Repeatedly press the reset knob on the maintenance indicator.
The yellow piston within the indicator is reset and the maintenance indicator is ready for use
again.
➤ Close the doors.
Dispose of old parts and contaminated materials according to environmental regulations.
10.4.3 Fuel system maintenance
Make sure no dirt enters the fuel system during maintenance. Clean components and their surround‐
ings before dismounting.
Material Spare parts
Receptacle
Cleaning cloth
Precondition The machine is shut down.
The machine is standing level.
The machine is fully vented, the pressure gauge reads 0 bar.
Machine is cooled down.
All compressed air consumers are disconnected and the air outlet valves are open.
The «battery isolating switch» is off.
10 Maintenance
10.4 Engine
No.: 9_9425 01 E
Service Manual Screw Compressor
M170 SIGMA CONTROL MOBIL
109