KAESER KOMPRESSOREN EPC-2-G Series, Сборка и руководство по эксплуатации

Страница: 66 / 96

Cleaning the air filter element by tapping. Cleaning the filter element with compressed air
1. Unscrew and remove the cover.
2. Withdraw the filter element.
3. Tap the element at the front a number of times
with the palm of the hand.
4. Clean the housing and sealing faces.
5. Replace the filter element.
6. Replace the cover and screw down tight.
7. Switch on the power supply disconnecting
device.
1. Unscrew and remove the cover.
2. Withdraw the filter element.
3. Use dry compressed air at not more than
5 bar to blow dirt from the air filter element
from inside to outside.
4. Clean the housing and sealing faces.
5. Replace the filter element.
6. Replace the cover and screw down tight.
7. Switch on the power supply disconnecting
device.
10.7 Drive Motor Maintenance
The drive motor bearings are permanently greased and need no re-greasing.
➤ Have the motor bearings checked during service.
10.8 Checking the oil level
The oil level can be read off on the oil sight glass.
Precondition The machine is switched off.
Fig. 25 Checking the oil level
1
Oil sight glass
2
Oil filler and crankcase vent
➤ Read off the oil level daily and before each start-up.
Result Top up when the compressor oil level falls to the minimum mark. Top up the oil
10 Maintenance
10.7 Drive Motor Maintenance
56
Assembly and operating manual 2-stage piston compressor
EPC-2-G
No.: 9_5753_04 E